// Blink pin 12 y 13 alternativamente
int led_12 = 12;
int led_13 = 13;
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin 13 as an output.
pinMode(led_12, OUTPUT);
pinMode(led_13, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(led_12, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(led_12, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
digitalWrite(led_13, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(led_13, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}
